Call us now
Phone: (+357) 24823938
PATTEX SILICONE ADHESIVE PISTOL 70W 11MM + 6 PCS. ERASER
Technical Information / Τεχνικές πληροφορίες
| Maximum outlet temperature/Μέγιστη θερμοκρασία εξόδου: | +100 °C |
| Voltage/Τάση: | 110-240V |
| Standby power/Φάση αναμονής ισχύς: | 12W |
| Power operation phase/Φάση λειτουργίας ισχύς: | 30W |
| Heating phase power/Φάση θέρμανσης ισχύς: | 70W |
| Maximum melting point/Μέγιστη θερμοκρασία για τήξη: | +170 ° C |
| Heating time/Χρόνος θέρμανσης: | 8-10 minutes/8-10 λεπτά |
| Bar diameter/Διάμετρος ράβδου: | 11mm |
Insert the Pattex hot melt rods into the back. Place the pistol on a durable wooden or cardboard substrate. Let the gun heat for 8-10 minutes. Slightly push the Pattex heat seal rod forward. Application: Apply the glue to one of the two welding surfaces, in moments or lines, lightly pressing the trigger. Immediately connect the two surfaces and apply pressure. The weld is mechanically durable after 2 minutes. Warnings: Installing a new bar: wait a while for it to heat up. If the still cold bar is pushed too far, it can get stuck and block the supply. Do not push the trigger hard, but wait for it to fully warm up. Unplug during a work break of more than 30 minutes.
| Brand | PATTEX |
|---|
Write Your Own Review
