RUSTOLEUM GALVA ZINC-ALU GALVANIZING PAINT 1KG

RUST-OLEUM® Bright Galvanizing 1017 is a fast drying, zinc rich coating based on an epoxy
ester resin. The product contains pure zinc and aluminium as pigments and provides cathodic
protection.

Withstands up to 500 hours or salt spray (DIN 50021 SS)
90% pure zinc in the form of dry film paint
Full protection for pure and galvanized steel
Heat resistant up to 300ºC
Excellent protection against moisture and salt spray

Coverage:11.5m²/L

Drying Time:30 minutes

Application Method:BRUSH

Use:INTERIOR & EXTERIOR

Tool Cleaner:WHITE SPIRIT

RECOMMENDED USES
RUST-OLEUM Bright Galvanizing 1017 should be used on new, bare steel, blasted steel or
galvanized steel surfaces.

RUST-OLEUM Bright Galvanizing 1017 is primarily intended for brush application on small
areas or for touch-up.

RUST-OLEUM Bright Galvanizing 1017 can be recoated with non-saponifiable coatings.

RUST-OLEUM Bright Galvanizing 1017 should be used as a single coat in light industrial
exposures, corrosive environments and high humidity areas.

TECHNICAL DATA
Appearance: Flat
Colour: Aluminium
Density: 1,77 kg/ltr
% zinc/alu: 76% in dry film (67,5% Zn / 8,5% Al)
Solids Contents: 41,8% by volume
Viscosity: 88 - 92 KU /Krebs Stormer Units at 20°C
Recommended film thickness: 35 µm dry, equals 85 µm wet
VOC-content: 477 g/l max.
Ready-to-use mixture: 497 g/l max.
Category: A/i
EU Limit value: 600g/l (2007) / 500g/l (2010)

Coverage
Theoretical: 11,5 m²/l at 35 µm dry
6,5m²/kg at 35 µm dry
Practical: Practical coverage depends on many factors such as porosity and
roughness of the substrate and material losses during application.

SURFACE PREPARATION
Remove grease, oil and all other surface contaminations by alkaline or high pressure (steam)
cleaning in combination with appropriate detergents. For optimum results remove rust, rust
scale, mill scale and deteriorated coatings by abrasive blasting to Sa 2½ (ISO 8501-1 : 1988),
blast profile max. 50 µm. The surface must be clean and dry during application.

DIRECTION FOR USE
To ensure homogeneity, coating materials should be thoroughly stirred prior to use.
To avoid settlement of the zinc pigments on the bottom of the can stir regularly during
application.

APPLICATION & THINNING
Brush: Up to 5 vol. %; RUST-OLEUM Thinner 160.
Use natural bristles, longhair brushes.

Cleanup: Use RUST-OLEUM Thinner 160 or aromatic hydrocarbons.

APPLICATION CONDITIONS
Temperature of air, substrate and coating material between 5 and 35°C and relative humidity
below 85%. The substrate temperature must be at least 3°C above dew point.

REMARKS
Maximum dry film thickness per coat: 75 µm dry, equals 180 µm wet.
RUST-OLEUM Bright Galvanizing 1017 should preferably be applied in a maximum dry film
thickness of 35 µm if recoated.

SAFETY
Consult Safety Data Sheet and Safety Information printed on the can.

SHELLIFE / STORAGE CONDITIONS
5 years from date of production in unopened cans, if stored in dry, well ventilated areas, not in
direct sunlight at temperatures between 5° and 35°C.