VECHRO CHASSI ANTICORROSIVE CHASSI PAINT

Anticorrosive alkyd enamel paint for car chassi and components’
protection.

Resistant to water, gasoline and car oils.

Gloss alkyd paint with low VOC content, suitable for protection
of cars’ chassis and other metallic equipment. Gives very good
adhesion, quick drying and very good water as gasoline resistance.

Texture: Gloss > 80 units in 60º.
Specific weight: 1,19-1,24 kg/lt.
Covering power: 12-14m²/lt per layer depending on the surface.
Dilution: Up to 5% on volume with SMALTOLUX WHITE SPIRIT for application by brush or roller and for spray application up to 12% on volume with No1 thinner of
VECHRO.
Drying: 1-2 hours touch free. Drying through 3-4 hours.
Recoatability: Recoatable 18 hours after application or after first layer’s hardening. These times prolong under cold and wet weather conditions.
VOC class: “One-pack performance coatings. Anticorrosion finishes”. Type SB. VOC limit =500 gr/lt. Max VOC of product ready for use= 490gr/lt.
It fulfills the requirements of E.C. legislation after 2011. VOC: organic volatile compounds with boiling point < 250ºC.

SURFACE PREPARATION
Clean the surface of dust, oil, cropped paints, rust. Sandpaper surface
before stain, especially if it was oil painted. Use solvent to clean the
surface before application.

APPLICATION
Stir well till thinner is fully embodied. Apply one-two coats CHASSI COAT.
For better protection, primed surfaces should be painted with the suitable
finish paint such as GUMILAK metal, SMALTOLUX extra or any enamel paint
from VECHRO.

CLEANING EQUIPMENT
While working keep your equipment wet, either in the pot, or in the paint
lauder. Strain well your tools from paint back to the pot and clean immediately with thinner, water and soap.

APPLICATION CONDITIONS
Temperature 8-30 ºC and relative humidity lower than 80%. Contrary
weather conditions may degrade paint’s quality.

STORAGE
Store in a cool place, protect from freezing and sun exposure. Close the
can well after application to keep in good condition. Recover unused paint
for re-use. Reuse of paint can effectively minimize the product’s life cycle
environmental impact.